|
|
|
|
|
|
|
|
|
|
|
For reference only.
|
For reference only.
|
Clevis pin for the accelerator pedal linkage
|
|
|
|
|
|
|
|
|
|
|
|
|
Early bowl nut copper crush washer
|
Throttle cable retaining clamp clip.
|
Air vent valve on pick up plate gasket
|
|
|
|
|
|
|
|
|
|
|
|
|
Wire type hose clamps for the large fill neck hose
|
Carb to manifold gasket
|
Early fuel filter head to bowl gasket
|
|
|
|
|
|
|
|
|
|
|
|
|
Fuel pick up plate gasket
|
Pedal spring extension to firewall
|
Elbow to Adapter gasket for Carter and Zenith Carbs.
|
|
|
|
|
|
|
|
|
|
|
|
|
Carter carb to elbow gasket triangular
|
This gasket goes between the air cleaner adapter and the air horn.
|
Includes one bushing only, weather seal shown for reference.
|
|
|
|
|
|
|
|
|
|
|
|
|
Used on the WC Dodge and the early M37.
|
Fuel tank to fill neck vent hose
|
Includes one weather seal only, bushing shown for reference.
|
|
|
|
|
|
|
|
|
|
|
|
|
Fuel resistant gasket that does not deform
|
Throttle return spring
|
NOS fuel pump mounting bolt.
|
|
|
|
|
|
|
|
|
|
|
|
|
Special pivot stud for the accelerator linkage on the manifold
|
Throttle cable mounting bracket on manifold
|
Air vent for axle housing
|
|
|
|
|
|
|
|
|
|
|
|
|
Air cleaner elbow support bracket front
|
Accelerator pedal lever
|
Air cleaner elbow support bracket rear
|
|
|
|
|
|
|
|
|
|
|
|
|
Accelerator to lever rod
|
The special brass fitting used on the inlet side of the M37 series truck fuel pump. The hose connects directly to this fitting and it also allows for the auxiliary fuel line connection for the heaters used on these trucks. No bushing or extra pieces needed to install directly to the pump.
|
Fuel pump inlet elbow
|
|